|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Sat, December 19th, 2009, 11:41 AM
|
||||
|
||||
The gotts mod is only about $20 at a hardware store. It is basically a 4 or 6 inch section of a 3 inch pipe with a 3 inch flexible PVC coupling. The "gotts mod" replaces the stock snorkel in the fender well. There is a very good write up on here. This explains everything and then some...
http://forum.gopowerhungry.com/showthread.php?t=340 
__________________
|
|
#2
Sat, December 19th, 2009, 12:07 PM
|
||||
|
||||
|
Just to add to this, unless you've increased the diameter of the TB, it acts as a choke point for airflow and I doubt the 4" intake can give you any benefit at all. But, since the two different sized devices were not really engineered for each other, I can see lots of potential for problems, as 88Racing said.
- Jack
__________________
 2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
