|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Sat, February 27th, 2010, 02:48 PM
|
||||
|
||||
My buddies '09 F-150 will do burnouts and stuff as long as u turn of the traction control. if you hold the button til the light in the dash starts blinking then the traction control, stability control, etc are all disabled. if your at a dead stop and you just hit the button it will turn off traction control, but not the other systems. tried to do donuts in it though and it won't do it(at least on dry pavement). i'm sure if it had a little more power then it would do ok, but all we have done to it is put a flowmaster super 44 on it.
__________________
Travis-- Death Row Diesel Inmate #7 1995 Ford F-250 regular cab long bed PSD MODS- 6637, TE modded 17*, Rosewood 160/80's, Tony's tunes, HPX, 120v IDM, 3" DP to 5" stacks, CPR fuel system, DRD traction bars, ISSPRO EV2's, scan guage, VALAIR full ceramic clutch, Midwest short throw shift kit 381hp/870tq 14.32 @ 97mph 
|
|
#2
Tue, July 17th, 2012, 12:27 AM
|
|||
|
|||
|
Searched on the forum and could not find a definitive answer... Does the Gryphon allow you to disable traction control and/or stability control? Or can Bill make a custom setting for it? I have read the Ford owners manual and holding the button 5 seconds will disable it up to 35mph, it is very hard to get places in the snow/mud when it kills your power at 35, also less fun
__________________
2009 F150 XLT 4X4 5.4 Edge CS / 2" Autospring Lift |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
