|
|
|||||||
| New Member Introductions
Welcome to the Power Hungry Performance Forum. We're glad that you're here! Start a new thread and tell us a little about yourself! PLEASE POST TECHNICAL and/or SUPPORT QUESTIONS in the APPROPRIATE SECTION of the FORUM |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Tue, April 20th, 2010, 03:07 PM
|
||||
|
||||
I would if she were in Ga right now but she aint she is with her parents in Or and that aint a small drive! Trust me I wish she was there cause I would let bill have the truck and my card and say have fun!
 Also Chuck I like your quote I wish you knew who said it I know I have heard it before but I don't remember where.
|
|
#2
Wed, April 21st, 2010, 03:17 AM
|
||||
|
||||
|
The best place to check for PMRs is to get the serial number off the engine (between the oil cooler and the flywheel). Might be a little messy though. If she can get that number, we can verify PMRs or Forged rods... at least as long as nobody has swapped them out during a rebuild.
Oh, and of course... Thank you for your service! 
__________________
Bill Cohron - The Mad Doctor   Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back  Windows™ XP and 7.  Windows™ Vista and Windows™ 8 is a pain in my a$$!  Windows™ 10 is only slightly less annoying!  Windows™ 11 is garbage!  Much to my surprise, I'm actually quite enjoying Linux! 
|
|
| Thread Tools | |
| Display Modes | |
|
|
2000 F350 AFE Stage 2, 5" MBRP with 6" tip and a PHP FU chip
Hybrid Mode
