|
|
|||||||
| Phoenix Switch-On-The-Fly Chip (DISCOUNTINUED) (Disabled) Power Hungry no longer sells the Phoenix/TS chip, but if you need custom tuning we can recommend a few really good tuners that will be able to still provide tuning and support for your chip. If you have any other questions or comments about the Phoenix/TS chip, please post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Mon, May 10th, 2010, 01:06 AM
|
|||
|
|||
Already have Php chip, adding new stuff?
bottom end let go a week ago at 160K
 . So while its out im adding forged pistons, a GTP38R and adrenaline. Do i need new tunes on my phoenix or is it ok the way it is? also how much would it cost to send mine in and get it reburned with the smokeshow and 140hp instead of the whisper and 120hp?
|
|
#3
Mon, May 10th, 2010, 09:15 AM
|
|||
|
|||
|
99 already has forged rods, but yes itll have forged rods, headstuds, 910 springs and hardened pushrods while im at it. Piston came apart.
|
|
#4
Mon, May 10th, 2010, 12:48 PM
|
||||
|
||||
|
Quote:
The tuning will be fine for the mods you listed unless you run into a "rolling" idle of 50-100 RPM. The idle speed fluctuation will come from the Adrenaline, but it's a SIMPLE fix in the tuning. As far as getting reburned with the tunes, it's only as expensive as the shipping here and back.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
|
#5
Mon, May 10th, 2010, 04:40 PM
|
|||
|
|||
|
What do you mean rolling idle? As soon as i get it back together ill ship it back. Love the chip just would rather have the 140 and smokeshow.
|
|
#7
Tue, May 11th, 2010, 08:26 PM
|
||||
|
||||
|
Quote:
A "rolling idle" is a condition where the idle speed slowly (like once every 5-6 seconds) will raise and lower about 50-100 RPM. It's not a problem, but it may be annoying.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim. |
|
#9
Fri, May 14th, 2010, 09:14 AM
|
||||
|
||||
|
Quote:
__________________
Bob- 2003 F250 Lariat 7.3PSD CC SB FX4 Kwik (6637) Filter, RE 2.5" leveling kit, F350 Rear Blocks, TC Lock, Fumoto, EBPV/Exhaust Brake,6.0 Tranny Cooler, AIH Delete, IssPro EV2 Gauges, PHP Phoenix stock, 25tow, 40tow, 65tow, 80dd, 100perf, In-tank mods, Muffler Delete, WW, FRx,HPx, JW Stage 1 Trans, Swamps HV/HF IDM -Pulling a 38' Forest River Sierra 5th Wheel 
|
| Thread Tools | |
| Display Modes | |
|
|
to say the least.
How ya doing?
I am on PSN also 
you know 
Linear Mode
