|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Thu, May 13th, 2010, 12:30 PM
|
||||
|
||||
I think you'll find, 88, that the voltage drops into the 10V (or even high 9V) range as you're cranking. That starter is pulling a lot of current. And, my radio, A/C and headlights are almost always on too. The truck is in a garage in low light and the headlights are auto-on.
But, you'll have to have your CTS ON to see it, and I find I rarely turn it on before cranking. Also, if the truck starts quickly, as mine does, you have very little time to see the voltage. - Jack
__________________
 2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
|
#2
Thu, May 13th, 2010, 01:26 PM
|
||||
|
||||
|
Yep.
Kick off some off the amenities like the auto lights and then turn key, wait for the CTS to boot up to the display screen, then start.
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
