"Gotts" mod. Remove silencer?

[Longshot270]

Yeah, I think that will work. Is it only about a 1/4 inch thick? Just make sure that the 3" connector will fit over it. I just checked the scrap I have and it says 3 inch coex cellular core. It looks like it has a super fine foam(an offwhite color) between two thinner white layers.

[Longshot270]

We kinda got off track. If the inside diameter is 3 inches, the material is rigid and it will fit in your connector then it will work. You dont have to use a specific material for this, just something that will work.

[LonestarROB]

Originally Posted by Longshot270

Yeah, I think that will work. Is it only about a 1/4 inch thick? Just make sure that the 3" connector will fit over it. I just checked the scrap I have and it says 3 inch coex cellular core. It looks like it has a super fine foam(an offwhite color) between two thinner white layers.

Sweet! Yea thats what mine says and looks like. Tag on the shelf called it Foam Core. Just wanted to make sure. Time to break out the sander i guess.

[Longshot270]

You dont have to use a sander if you dont want to. I used a regular hack saw to cut a notch then cleaned it up with my pocket knife and it turned out just fine.
http://forum.gopowerhungry.com/34493-post200.html

[LonestarROB]

Made a(possible) interesting discovery. This is the piece, that goes into the fender, from the S&B CAI being removed.





It's exactly the right size(obviously) to fit the hole. Couldn't it be made to work and not need the PVC?

[Longshot270]

That will fit into the fender perfectly but the intake might be just a bit too far away to connect. Try it and take some pictures so we can see.

[LonestarROB]

bah, yup its far too short. Back to work.

[Longshot270]

Thats fine, if you look at my picture from the kidd4cars thread it didn't initially have the groves cut on the top. I added that afterwards to make it easier to clip in.