|
|
|||||||
| Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Wed, July 7th, 2010, 12:06 AM
|
||||
|
||||
Hmm, well I can tell you that I honestly didn't know the answer until you asked. So I opened up Minotaur to see if I could investigate. While you have a project open and have the project window selected, you can select "Mark" on the toolbar and then pick Help. This will bold different variables that help information has been filled in on. Closed and Full Throttle defaults happen to be bolded. You can then select the bold item in its respective parameter, map, function window and press F1. These happen to say "This is the default value used when a sensor error has been detected." Now what causes the PCM to think there is a sensor error I'm not sure.
__________________
Thomas H. '97 F-250 CCSB 7.3L Auto, Gauges, Modded H2E, 285/200% sticks, 7.3L IC, Stealth Dual HPOP, Pheonix chip '03 F-250 CCSB 6.0L Auto, Gryphon CTS, FICM tuning by PHP, Powermax 
|
|
#2
Wed, July 7th, 2010, 10:28 AM
|
||||
|
||||
|
Those are sensor error defaults. If the APP sensor is open or shorted, these are the minimum and maximum values that are allowed.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim.
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
