Not really. Keep the Gryphon in the house till you're ready to install it. Get the truck's PCM nice and warm by running it. If you plan to mount it on your dash right away get the cable down and into position and up through the plastic mount now, before you start warming things up. Remember, the cable is not connected to the OBDII port from the Gryphon until you turn the ignition key ON (with the engine off). Keep your radio, AC blower, lights, etc off to minimize drain on the battery.
You should be good to go!
- Jack
__________________
2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam
|
Thu, February 19th, 2009, 06:45 PM
Threaded Mode