|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Tue, January 11th, 2011, 10:24 PM
|
||||
|
||||
Got the fail safe error again today. I immediately checked for codes and this this is what I got. And again I turned her off and started back up and all was good. Same I was leaving work and as soon as I pulled out of the parking lot bang, fail safe.
P061B Internal Control Module Torque Calculation Performance Anyone have any idea what this is?
__________________
 Mike
|
|
#2
Tue, January 11th, 2011, 10:40 PM
|
||||
|
||||
|
After reading a bit in the forum, I see that this code may be related to the tune. Everything that I have seen says canned tunes, but I am running a custom 87 perf tune. Please help!
__________________
Mike
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
