I had my truck scanned today. Codes p0603 internal control module ram error, p0783 3-4 shift error, p0781 1-2 shift error, p0732 gear 2 incorrect ratio. About 3 days before I started having tranny problems, my truck died pulling into the parking lot at work and wouldn't restart. I let it set until after work, when I got into my truck, I made sure my chip was firmly seated. I put the key in and it started right up. Is it possible I partially fried my pcm, or maybe it needs to be re-flashed? The shop said the tranny was junk. Yesterday I drained the fluid and dropped the pan expecting to see some shards or something. Nothing in there but some fines and the fluid was little burned. I don't know if I trust this shop or not. I think I will get a second opinion, what do you guys think?
Mon, May 2nd, 2011, 07:00 PM
Threaded Mode