New chip - How to remove Banks stuff?

[txjeep]

I assume I must remove this Transcommand before I put the Phoenix in, right?

[Power Hungry]

You don't HAVE to remove the TransCommand, but you might find your shifts to be a tad aggressive.

[txjeep]

Okay, thanks again. I figured out the wiring and what to do now, so I am going to remove it.

I assume the Banks chip comes out in the reverse order that the PHP chip goes in?

[cj45lc]

Originally Posted by txjeep

Okay, thanks again. I figured out the wiring and what to do now, so I am going to remove it.

I assume the Banks chip comes out in the reverse order that the PHP chip goes in?

Did you get the trans wires straightened out?

Yep the chips should just un-plug & plug-in from the PCM, they say to make sure the key is NOT in the ignition when you do it but I always un-hook the batt cables when I fool with the chip

[txjeep]

Yes, I just removed the trans module. Next is to swap the chips and mount the switch. Where do folks normally put the switch?

[txjeep]

Just took it for a spin. Didn't get to really test it out, but so far I am very pleased. The "theft" light blinks a lot. Is that normal? Also, will a key without a chip work in it now? Seems like I read that somewhere.

Thanks for all of the quick help!

[cj45lc]

Originally Posted by txjeep

Just took it for a spin. Didn't get to really test it out, but so far I am very pleased. The "theft" light blinks a lot. Is that normal? Also, will a key without a chip work in it now? Seems like I read that somewhere.

Thanks for all of the quick help!

yep it's a pretty nice difference huh, as far as the switch I put mine by my right knee in the lower dash just right of the fuse panel cover. Some folks have put them in some pretty neat spots so look around on PSN or some of the other sites or maybe google TS switch.

Someone alot smarter than me will have to give you some answers on the theft light deal, BTW welcome to the PHP crew.