![]() |
|
2004 to 2008 F-150 and Mark-LT 4.2L, 4.6L and 5.4L equipped F-150s and Mark-LTs. |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I'm going to be running a Magnaflow DIDO with built-in crossover so I should be able to keep it pretty close to that area.
|
#2
|
||||
|
||||
![]()
I had one of those in my first truck, it was nice with a good sound, and no tuning changes were required. the stock y is usually fairly far in front of where the muffler goes, and to the best of my knowledge, most shops put the new muffler in the same spot as the old one, which is a few feet away from the stock Ypipe.
I dont think it will be a problem, but if you are too worried, then I would recommend calling Bill and asking him. Hope that helps ![]() |
#3
|
||||
|
||||
![]()
That muffler with the built in cross over likes to pop and cackle......most people end up putting the X crossover in front of it to make it sound better......
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
#4
|
|||
|
|||
![]()
I had one on my 07 crewcab and I dont remember any poping or anything, but good to know.
|
![]() |
Thread Tools | |
Display Modes | |
|
|