My DYNO results are in.

[Jackpine]

Good grief! I'm seeing something in the range of a 20-30% increase (without actually doing any calculations)! Do you really want to take this hunk of iron and try to subject it to more without having it specially made? There IS a limit, you know, to the stresses you can put on a collection of mechanical parts that were manufactured for the "masses".

- Jack

[88Racing]

Just remember the numbers are at the wheel and not at the block.
I am with DJ, if it's going to cost another $4k to get it any better then settle any debt and invest.

Lars

[dlmcbm]

Yea, By no means do I have $4000 just sitting around to burn. There are a lot of thing that would go to first. Ya never know I may hit the lotto soon Thats right you have to pay to play it first. Just wondering if I came across something what would be best to get. When I talked to Bill he said I did not have powder metal rods so thats a plus. If I can get a good scan of the print out I will post it. The power curve is so much better then stock. Stock has a bad drop off around 2600 rpms.

thanks guys