Is there anything I could physically do after installation to mess up the proper running of my truck? Since I installed it 2 days ago all I did was set it to program# 2 and set the tire size. I haven’t drove it much just a couple times up and down the block to test it and to move it around during the day.
Also this morning the auto start didn’t work for me! I hit the button but it would not crank?!?
This evening using the key drove down the block and stalled. The engine would turn over but not start!
I towed it back to my garage, disconnected the battery for now and I will try it again in the morning.
Any ideas?
Fri, July 10th, 2009, 10:51 PM
No start issue
Threaded Mode