|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Wed, January 13th, 2010, 05:35 PM
|
|||
|
|||
Transmission temp not reading
Just installed the gryphon for my 99 ford f250 7.3 diesel. Not reading transmission temp, is that something I need to get another probe for?
Thanks travis |
|
#2
Wed, January 13th, 2010, 05:57 PM
|
||||
|
||||
|
I looked at the website:Power Hungry Performance - Gryphon Dash Mount Programmer for 7.3L Power Stroke Diesels
It says in the read out section its supposed to read it but there might be a cut off in years though.
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
#3
Wed, January 13th, 2010, 08:09 PM
|
||||
|
||||
|
After further research you are supposed to get TFT readings.
Hopefully Cody can answer if it could be a faulty sensor.
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
#4
Wed, January 13th, 2010, 08:47 PM
|
||||
|
||||
|
Jeremy might know too!
But sadly, 88 and I don't have a clue. This might be a good thing for you though, if your sensor is indeed faulty. I suspect Ford installs them for a reason and if so, they should be operational. - Jack
__________________
 2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
|
#5
Thu, January 14th, 2010, 02:42 PM
|
||||
|
||||
|
The PCM does look for transmission fluid temperature to assist in torque converter clutch apply rates, shift scheduling, etc.
I have run into certain trucks that do not support TFT in the data stream (on a scanner) so that may be an issue with your Gryphon.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
|
#6
Thu, January 14th, 2010, 09:29 PM
|
||||
|
||||
|
Quote:
I don't suppose you know if the PCM does this for gassers too? Makes sense that it might, and it would justify the sensor being there - otherwise, why have it? Maybe Bill will have some idea if the OP's truck supports this when he gets back, if Jeremy doesn't know. - Jack |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
