![]() |
|
Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
If you aren't sure about the datalog feature this should help out...
http://forum.gopowerhungry.com/attac...g-write-up.pdf ![]()
__________________
|
#2
|
|||
|
|||
![]()
Ok. I will try to get a data log but now when I connect, I am getting this error message...
Unable to determine Gryphon Model. The Gryhpon may be in 'Run' mode, is currently set as stock writer,or memory is corrupted. I reset back to stock before trying the updates. It still wouldnt update what it stated I needed unless I did both updates. So, updated both, then downloaded custom tunes again... ![]() |
#3
|
||||
|
||||
![]()
Humor an old man -
It sounds like you successfully updated both the firmware AND the calibrations on your Gryphon through Pegasus, right? And THEN, you successfully downloaded and reinstalled your custom tunes through Pegasus, right? But now, when you connect the Gryphon to your truck, it gives you an "unable to determine Gryphon model" error message? This is most puzzling, because this error is normally only seen in Pegasus when connecting to the PC, and I can't for the life of me figure out why you'd still be mucking around with the PC, since you've done successful updates. If you ARE seeing this message on the Gryphon's screen when connecting to the truck, you DID have the ignition key in the ON position before connecting the Gryphon, right? If nothing I say is helping, it sounds like you will have to get Bill's help on this. I'm out of ideas. - Jack |
#4
|
|||
|
|||
![]()
I was prob unclear as to what happened. When it asked to reconnect... once reconnected.. this is when the error appeared. I do not get the option of hitting the 'ok' that is prompted for after a reconnect do to the error. When I go to the update for custom tunes, this option is still available.. I dont think it is finishing the update.
|
#5
|
||||
|
||||
![]()
Interesting issues you have.
"You may see this error in Pegasus when connecting the Gryphon to your PC to download custom tunes. You should still be able to use the [Targeted Functions] menu option in spite of this error. As long as the firmware hasn't been damaged during an update causing the serial number to be lost, Targeted Functions can usually recover the unit. If this is not possible, contact PHP for assistance."
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
|