|
|
|||||||
| F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Fri, August 26th, 2011, 12:58 PM
|
|||
|
|||
Running an FU without an exhaust upgrade
Hey Guys I'm looking at getting an FU chip only question is I haven't upgraded to a 4 inch exhaust yet. It is in the plans but can't buy it all at once. I have installed all the guages (EGT, Trans Temp, Boost) will I be ok just going with the chip for a while as long as I keep an eye on my EGT's I was figureing I would just run the low hp tunes such as 20 hp tow 60 daily driver until I do the exhaust.
Any experience or reccomdations running without and upgraded exhaust 02 F350 Crew cab 7.3L |
|
#4
Sat, August 27th, 2011, 05:58 PM
|
|||
|
|||
|
As long as there isnt a cat/stock muffler in the way you're fine.. i can nail 1200* if i try real hard.. but dont worry.. just watch your pyro!
__________________
2002 7.3 F250 Supercab Shortbox DIY intake CCV dumped Autometer gauges WW/ATS 1.0 exhaust housing Hutch/Harpoon in tank mods/hpX line AIH delete/ebpv delete TruCool trans cooler Straight piped PHP FU 
|
|
|
Linear Mode
