Two Codes

kbates · #1 Tue, December 20th, 2011, 12:40 PM

My Truck 2010 5.4L Fx4
edge CTS programmer

I just put new tires on my truck and wanted to correct the speedometer. So I downloaded the stock programming. Once complete I selected the stock programming again and set the tire size. All seemed well after initial drive last night.

This morning wake up to two codes P0605 and P1000. After reading I turned them off and went to work. Started truck up again and codes appeared.

After Lunch I will be returning all settings back to stock. I also replaced my air filter 1 day prior to updating my tire size.

I am currently waiting on custom tunes.

Do I need to try to reinstall the tire size?
leave it all stock untill custom tunes?

Any help would be appriciated.

Thanks

***88Racing*** · #2 Wed, December 21st, 2011, 10:18 AM

The p1000 is a relearn code....

The p0605 is a corrupt file code....

When changing tire size a canned/custom tune needed to be used......using stock programming it shouldnt be able to be done....

kbates · #3 Thu, December 22nd, 2011, 12:45 PM

So after all this I returned the truck back to stock and still have the P1000 code (re learn). I am sure it will go away after re learning is complete.

I did not know that using the stock programming and using the custom features to modify the tire size could not be done.

thanks for the information

***88Racing*** · #4 Thu, December 22nd, 2011, 03:31 PM

You can change the tire size only when a canned/custom tune is going to be loaded....