|
The Conversation Pit This is where EVERYTHING else goes. No subject is too mundane. How's the weather in your area? Did your kid cut his first tooth? Really, what do you think about the President? And don't get me started on Cummins and Duramaxes. Have at it! |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Another gem in the shop this week.....
Early 99 Powerstroke. Regular cab dually with a 6-speed. Customer says that it starts fine in the mornings but if you take off and drive it immediately or before the temperature gauge goes above the first line, it will lose power and die. Restarts take some coaxing.
Well, a good technician always tries to duplicate the concern. Well, yep, it did it. I got 1/4 mile down the road the following morning and sure as heck, it starts sputtering and losing power until the pedal is dead and I coast to a stop. Cranks fine and eventually starts after about 10 seconds. It's missing and carrying-on for a few seconds and after about 10 seconds runs fine again. I turned around and headed back to the shop. The following morning, I checked the oil level before I started it: there was nothing on the dipstick. I hooked up the scanner knowing at this point what was going on. Sure as the sun rises, same thing. This time, the scanner caught the ICP dropping to nothing and the IPR going full tilt. I just find it hard to imagine being able to run a truck for 10,000 miles on an oil change, never checking it, and only doing something about it once you get so frustrated with the truck stalling every time you drive it........The engine had only 5 quarts of oil in the pan. 15 quarts of oil later and purging all of the air from the high pressure oil cavities in the head and it's back in business. Oh, and since it's an E99 with a broken tab on the air box, the compressor wheel is nearly gone and it turns over REALLY fast while cranking. To make matters worse, the guy uses the truck for his fencing company so it LIVES on dirt roads and cow trails. The intake tube was lined with DIRT...not dust...DIRT. SAWEEEEET!
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#2
|
||||
|
||||
Hope he's better at building fences than maintaining vehicles (that provide/support his job).
__________________
"Good judgement comes from experience. Experience comes from bad judgement." - Colin Powell to new batch of 2LTs (while serving as V Corps Commander) Factory manuals here: http://www.motorcraftservice.com |
#3
|
||||
|
||||
Sadly this does not surprise me. I've seen it plenty of times down here.
__________________
|
#4
|
||||
|
||||
I see alot of "farmed" pickups up here also.....its sad people treat their vehicles like that and then expect them to run perfectly.....
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
#5
|
||||
|
||||
Good Lord! I'm surprised it could run at all.
- Jack
__________________
2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
#6
|
||||
|
||||
Ran ok when warm....but then again the oil would drain back to the pan fast enough to keep the pickup tube somewhat submerged in oil when it was warm.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#7
|
||||
|
||||
Wow... I bet he thinks he's got a REAL good starter in that one.
__________________
Thomas H. '97 F-250 CCSB 7.3L Auto, Gauges, Modded H2E, 285/200% sticks, 7.3L IC, Stealth Dual HPOP, Pheonix chip '03 F-250 CCSB 6.0L Auto, Gryphon CTS, FICM tuning by PHP, Powermax |
#8
|
|||
|
|||
talk about getting your money worth out of a oil change, I hope you billed him good...lol
__________________
2000 F-250 SCLB 2wd 7.3 auto PHP stock-65t-80dd-120race-high idle-no start 4"tb exh, wicked wheel, 3 guages, AIS, coolant filt, |
#9
|
||||
|
||||
Job Security! I overhauled a tractor for a customer once, wrote the hours down on the filters and told them they needed to change it between 30 & 50 hours the first time. I stopped by to see how everything was going and the filters i put on were still on and the hour meter had around 300 more hours on it. Warranty Voided
__________________
Put a Turbo on it!!!! '95 F-250 Powerstroke, 350,000 Miles, Mods: Phoenix chip, 140V IDM, Diamond Eye DP to 4" straight pipe, CCV mod, Amsoil synthetics throughout. '04 F-350, XLT Lariat, Powerstroke, CC, Dually, SS exhaust, AirRaid intake and filter, Edge Evolution, PHP FICM programmer. |
#10
|
|||
|
|||
geez man thats a good one.. I sure hope hes ready for a rebuild cuz that motors DUSTED..
__________________
2002 7.3 F250 Supercab Shortbox DIY intake CCV dumped Autometer gauges WW/ATS 1.0 exhaust housing Hutch/Harpoon in tank mods/hpX line AIH delete/ebpv delete TruCool trans cooler Straight piped PHP FU |
|
|