Power Hungry Performance Forum
Page 2 of 2 1 2
Show 100 post(s) from this thread on one page

Power Hungry Performance Forum (http://forum.gopowerhungry.com/index.php)
-   Minotaur Automotive Tuning Software (http://forum.gopowerhungry.com/forumdisplay.php?f=8)
-   -   Getting files from Minotaur to chip (http://forum.gopowerhungry.com/showthread.php?t=5694)

rusty1161 Thu, September 13th, 2012 02:42 PM
Quote:
Originally Posted by Shaw (Post 60870)
File -> Save calibration as... -> change name of calibration and hit save.
Thank you.

I did that and the file size is 1KB, versus the original 221KB. Does this sound right?

Thank you, again.

Rusty

Shaw Fri, September 14th, 2012 10:54 AM
No, that does not sound right.

Hmm, you sure that you arn't trying to save it as a project. That is the only way It should read that small. Make sure you are hitting - "Save Calibration as..." and not "save project as"

rusty1161 Sat, September 15th, 2012 02:34 PM
Quote:
Originally Posted by Shaw (Post 60955)
No, that does not sound right.

Hmm, you sure that you arn't trying to save it as a project. That is the only way It should read that small. Make sure you are hitting - "Save Calibration as..." and not "save project as"
That did it for me. Thank you!

Rusty

GTS Wed, September 19th, 2012 05:04 PM
OK so now I've got the new phoenix software version since I wiped and reloaded my harddrive. How it appears the new software is looking for a .efu file when I try to load my files on the chip but all my files, including the new one I just created, are all .bin files so it won't see them. I tried to just rename the file as a .efu but that didn't work either. I got an error message. How do I get the programmer to see the files I want to program onto my chip?


All times are GMT -4. The time now is 12:39 PM.
Page 2 of 2 1 2
Show 100 post(s) from this thread on one page


All Contents Copyright 2008-2024, Power Hungry Performance