TIP: Switch mounting like a clock
 

In order to be able to quickly tell which position my chip is on, I oriented it like a clock - turns out that the angle between positions comes out almost exactly right:

Position 1:
http://bitecode.net/switch/1.JPG

Position 2:
http://bitecode.net/switch/2.JPG

Position 3:
http://bitecode.net/switch/3.JPG

Position 4:
http://bitecode.net/switch/4.JPG

Position 5:
http://bitecode.net/switch/5.JPG

Position 6:
http://bitecode.net/switch/6.JPG

Very nice. Simple and accurate.

OK, so just to confirm, to get to position 1 on the 6 position chip, i just wind the knob counter clockwise until it will not go any further, and that is position one (1). every click to the right (clockwise) brings it to a new position.

I just wanted to make sure i was using the right settings, and it wasnt the reverse.

Thanks from a newb