![]() |
|
Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Got a strange problem, and after tons of searching I found it to have happened to a few other people. The posts always ended with out a solution though.
Here's what I have. 2001 F150 5.4 Edge Evolution. Truck runs fine on canned 0-1-2-3 settings. The problem occurs when I try to change the trans settings in the custom options. It happens with all three levels. I am just looking to raise up the WOT shift points, firm them up, and raise the standard shift points as it shifts too early. When ever I do that, the truck will run rich, black smoke, barely idles (if it does), and even threw a code. (TPS inconsistant with MAF ?). When this happens, the Engine Load readout stays around 80%,doesn't change at all. On my display, running my normal #2 tune, with the tire ratio and gear ratio corrected, I have also noticed strange things happening. The current gear in the upper right corner will read 1-2-3-4. No P-N-R, even when in P-N or Reverse,it just shows 1. Also no Tq converter lock is ever shown, even when locked up on the highway. With the current gear in the upper left corner, it reads 1 locked, In park. Then 2-3-4 unlocked. Depending on where I have the engine load% readout, it will read the same number as what I have next to it,whether it RPM or voltage,etc. I started talking with Edge a few weeks ago, gave them the info and up-loaded my programmer for them. Still no information on what to do next. Here are 2 pictures of the display taken back to back. I simply moved paramaters around. The truck was in PARK at the time. ![]() ![]() I'm at the point now where I'm ready to box it up and send it back. Any ideas on what to do next?? Steve |
Thread Tools | |
Display Modes | |
|
|