Never had problem with the pcm casing causing randon shutoff. What I did was put cord holders along the side of the PCM casing to "snake" the cable through. That keeps tension on the cable and holds it in place.
Only problem I have found is the little solder joints on the end of the chip. Slight vibrations and and removing/installing the chip have caused the sharp solder joints to scratch some of the PCM circuits that lead off where the chip slides on. For this, I put some liquid tape over those solder joints so they are not so pointy.
__________________
01 F350 7.3 4x4 CC SRW/3.73/315-75-16/Aeroforce Interceptor/BD Thruster II/ Bellowed Up-Pipes/4" turbo back exhaust/CCV Mod/DIY 6637/FPR Shimmed to 65 PSI/TS chip reburned with PHP tunes (Stock, 40T WITH Whsiper tune, 80DD, 100R, 140Ex, 140SS)/Replaced and Cleaned EBPS & Tube 4-6-12/Zoodad mod/Recon smoked cab lights/MM Hubs/Cowl Hood/HPx
|
Mon, May 16th, 2011, 11:39 AM
Threaded Mode