|
|
|||||||
| F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
|
Thread Tools | Display Modes |
|
#1
Fri, August 7th, 2009, 10:03 PM
|
|||
|
|||
NEED HELP:help: (FIXED)
Just programmed and installed FU per directions.
p1=stock p2=whisper idel p3=80hp tow p4=100 lope idle p5=120 extreme p6=no start When installed i get no change when turning nob. It seems as if chip is not there. Reprogrammed chip again. I'm getting a succesful write message, cleaned contacts again same result????? Any ideas? Did i clean contacts too much on pcm? Slightly removed some of the silver but was showing copper underneath? Just wondering if anybody else had issues at first?
__________________
2002 F-250 CrewCab LB AFE ProGuard 7 intake 4" Magnaflow ss exhaust with 4" downpipe BTS Trans Valvebody Dieselsite Adreneline HPOP Garret GP38R turbo PHP Phoenix FU Last edited by mkf350; Sat, August 8th, 2009 at 01:13 AM. Reason: fixed |
|
|
Threaded Mode