![]() |
|
Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
These aren't stock tires. I usually run them around 41-43 then up them to 50 when I tow the boat.
The custom tunes came with the value 2550. I just dropped it down to 2449. There is one of those parked cop things that displays your speed, I'm going to drive by that a few times to get it where it needs to be. |
#2
|
||||
|
||||
![]()
Good! I just subtracted 2.8% from 2550 and came up with 2479. I suspect 2449 will be much too low. I'd try something in the 2500 range as a start.
- Jack |
#3
|
|||
|
|||
![]()
Argh, when I change the tire size and it goes throught the 4 stages, it doesn't save the change when I restart the truck. What am I doing wrong? I did the same thing before custom tunes and it stuck.
|
#4
|
||||
|
||||
![]()
When I go into check the tire size or any other changes. I do the following.
Open CO menu. Then load previous settings. Then to tire size usually says 2484 Then to gear ratio usually says 3.73 Then save changes/done. Or follow this link: http://dygytalworld.ehost-services13...newpost&t=1101 Lars
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
#5
|
||||
|
||||
![]() Quote:
- Jack |
Thread Tools | |
Display Modes | |
|
|