![]() |
|
2008 to 2010 6.4L Power Stroke Diesel (Disabled) 6.4L Power Stroke Diesel equipped Super Duty. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
My name is Jeff Eshelman.
Thanks for the help! ![]() |
#2
|
|||
|
|||
![]()
If you need an email address or my PCM/TCM codes let me know.
Thanks again!! |
#3
|
||||
|
||||
![]()
If you want us to help you, could you at least fill out the information in your UserCP? We can't do much for you if you "hide" from us.
- Jack |
#4
|
|||
|
|||
![]()
Yes sir, filled out all the information now
![]() |
#5
|
|||
|
|||
![]()
Mine does the same thing and this has been on ongoing issue. After my last update from both Ford and PHP it went away but once again it returned on my way to the airport last week. I may just go back to stock but hate to see the MPG go back to where they were as well.
My user CP should tell you who I am but once again, I am traveling all next week. |
#6
|
||||
|
||||
![]()
Couple questions...
Are we dealing with an EGT issue or a shifting issue? In what level(s) is this occurring? Current ECM/TCM strategy? (Check in Version Info) Current Firmware and Calibration versions? (Again, Version Info) In regards to the shifting concern itself, please define "not shifting very well". Shifting early? Late? Too soft or slipping? Too aggressive? Which shifts? (1-2, 2-3, etc.) Thanks.
__________________
Bill Cohron - The Mad Doctor ![]() ![]() ![]() Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Much to my surprise, I'm actually quite enjoying Linux! ![]() |
#7
|
|||
|
|||
![]()
I was the one who talked to you on the phone two weeks ago and had the higher egt's and trans shifting problems. I have been running the older calibrations and have had no problems since. My shifting problems were 1-2, 2-3 it seemed it did not know what gear it wanted to go into, then when it would shift it would clunk into gear pretty good. If you need all the info on teh truck again just let me know.
Thanks for the help! |
Thread Tools | |
Display Modes | |
|
|