|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Wed, August 12th, 2009, 12:19 AM
|
|||
|
|||
Yeah im not sure what he was talking about when he dropped the truck off i told my wife to send me a pic of gryphon, it was on level 3, so i called him and asked if he put a higher octance in it and he said no, but he had a error code 8? I had my wife turn the gyp back to 0 until i could figure out what he was talking about, but the truck runs fine, what can i do to get it to show that code again. If I have here unplug it and plug it back in> Thanks!
__________________
United States Air Force OIF 07 & 09 2007 F150 FX4 SCREW Gryphon Programmer |
|
#2
Wed, August 12th, 2009, 12:25 AM
|
||||
|
||||
|
I don't even know what an error code 8 is! The first unit error code is 0x11.
Do you think your wife would be comfortable installing it with me on the phone or is it something you'd prefer to either wait or have a shop handle with me on the phone? What baffles me is that it was in level 3 so the vehicle obviously programmed ok, so when did the "Error 8" occur? Let me know how I can help.
__________________
Bill Cohron - The Mad Doctor   Power Hungry Performance - The ORIGINAL in Ford performance tuning... Since 1997! (678) 890-1110 www.gopowerhungry.com - Home of the Hydra Chip, Minotaur Tuning Software, and the new Orion Reflash System for Navistar! Bring back  Windows™ XP and 7.  Windows™ Vista and Windows™ 8 is a pain in my a$$!  Windows™ 10 is only slightly less annoying!  Windows™ 11 is garbage!  Much to my surprise, I'm actually quite enjoying Linux! 
|
|
#3
Wed, August 12th, 2009, 09:33 AM
|
|||
|
|||
|
Yeah I dont think the guy knew what he was talking about? He is a dealer of Edge, he said he called Customer support for edge but they wouldnt help him. I tried to tell him it was re programmed. But is it fine if my wife runs in on level 1 without changing the gear/tire setting? Im going to have her unplug it and re plug it in to see what it says. Will respond back with info.
__________________
United States Air Force OIF 07 & 09 2007 F150 FX4 SCREW Gryphon Programmer |
|
#4
Wed, August 12th, 2009, 09:52 AM
|
|||
|
|||
|
She unplugged it and plugged it back in, it said "ECM not found" then it went to the main menu screen. Is that good or bad?
__________________
United States Air Force OIF 07 & 09 2007 F150 FX4 SCREW Gryphon Programmer |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
