Help with deciding settings on 6-position

[AZStang]

Thanks guys. I like the way the trans shifts now and I definitely don't want it to shift any harder. I also want to make sure it lasts.

I'm not all that informed about the chips out there, but any chance the DP-Tuner gauge switch would work with the TS chip? Do you think the knob you offer would fit inside of a ±2" gauge opening? Not sure how that would look though.

Curious too about if I get the chip and the trans doesn't shift to my liking. Am I just out of luck or can I send it back for modification?

Thanks,
Shawn

[Power Hungry]

We've been asked about the switch a few times. Unfortunately, it doesn't control the same way the rotary knob does. We're looking at possibly getting some gauge "shells" made which would allow the relocation of the switch to the pillar pod.

As for updates, you just send the chip back in for any tweaks. We also off the burner in the FU package which means you can make immediate changes to your files instead of sending the chip back in.

[AZStang]

Thank you Bill. I've never driven a truck with a chip before so I am not even sure I would like the push buttons over a knob anyway. In fact, the rotary knob may be easier to use. Just need to decide where I could mount it though.
Does the rotary switch come with a sticker or numbered mounting plate to show what setting number it is on?

Thanks,
Shawn

[cleatus12r]

I make my own brackets that mount below the dash or in the cubby hole since I hate drilling holes in dash panels.

As for the numbered stickers, you might be able to get small numbered stickers that you can affix to the switch plate.

[Power Hungry]

Originally Posted by cleatus12r

I make my own brackets that mount below the dash or in the cubby hole since I hate drilling holes in dash panels.

As for the numbered stickers, you might be able to get small numbered stickers that you can affix to the switch plate.

Got any brackets for sale? We can pay you in Gameroom cash...

[cleatus12r]

I don't need you to hand out your dirty gameroom cash....Roulette pays pretty good.

Besides, they're nothing special. They are 1" x 1/8" angle painted interior color with fancy rounded corners. I painted hash marks at every chip setting on one of them.

[AZStang]

Just a few more questions, I promise.

1. The order form says that the 25hp Tow is for towing extremely heavy, and the 40hp Tow is for heavy towing. If I never tow over 6,000 lbs, why would I need these tunes? Is this order form written more for guys with the monster injectors, big HPOP, and a big turbo?

2. What difference would I see between the 25hp Tow and 40hp Tow?

3. What would be the difference between the 65hp Performance tune and the 65hp Daily Driver? Would one use more fuel than the other?

4. What would happen if I tried the 100hp Performance tune?

5. I don't want much smoke, will the 65hp Performance tune cause a lot of smoke?

6. I currently roll the truck down to the end of the driveway in neutral before I start it so I don't wake the kids. How much quieter is the Whisper Mode?

Thanks,
Shawn