![]() |
|
F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
I put mine on the left side of the steering wheel centered under the headlight switch. It is very low profile and that is what I wanted.
I had to take the fuse block off it's mounts to run the switch wire and mount it back up when I was done but it was not that much work and I think it was worth it. I will try to send a picture later Joe
__________________
4" Down pipe and exhaust, Wicked Wheel, Modified Exhaust Turbo Housing, Big Head Waste Gate Actuator, PML Transmission Pan, Factory Tech Valve Body, Autometer Gage Pod, PHP FU2 Chip |
#2
|
||||
|
||||
![]()
I put mine here, very easy to reach and change w/o having to look away from the road.
![]()
__________________
the ![]() ![]() |
#3
|
|||
|
|||
![]()
mine is hanging from the trailer brake controler, havn't gotten around to drilling the hole in the dash yet. Give me some time, it only took me 1 1/2 years to finally install my gauges in the truck...
![]() |
#4
|
|||
|
|||
![]()
Can't tell you. It is in stealth mode
![]() |
#5
|
||||
|
||||
![]()
Between the headlight switch and the front/rear tank switch. Fits like a glove, and if you weren't lookin you would not see it.
|
#6
|
|||
|
|||
![]() Quote:
![]() I don't think mine would fit there. ![]() |
#7
|
|||
|
|||
![]()
Mine is down low in the lower panel to the left of the steering wheel, I just used the hole from my old 3-step chip form Bill way-back-when.
I am going to move it though. This is giving me some good ideas.
__________________
Proud father of a U.S. Army veteran, proud uncle of an Active Duty U.S. Army Ranger. '97 F-350 CC LB 4x4-Orignal Owner. Arrowcraft DRW Kit, Tymar int., Banks IC, Beans D-66 Turbo, Hypermax DP, 4 inch exhaust, ATS Triple Loc converter, Mag Hytec Trans Pan,Tru-cool Trans Cooler, ORU Shackle Reverse, Ultralite Gauges, PHP F.U. 2 Flex 6 pos. chip Terminator modded 17* HPOP and Scan Gauge |
Thread Tools | |
Display Modes | |
|
|