|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Sat, January 2nd, 2010, 10:48 AM
|
||||
|
||||
Jack or 88 (moderators) will probably answer with, "Check your battery."
__________________
"Good judgement comes from experience. Experience comes from bad judgement." - Colin Powell to new batch of 2LTs (while serving as V Corps Commander)  Factory manuals here: http://www.motorcraftservice.com |
|
#2
Sat, January 2nd, 2010, 11:03 AM
|
|||
|
|||
|
Everything seems "ok" with the battery as far as amps go...don't know what else to check.
So, I unhooked the Gryphon from the truck. Plugged it back in (with the truck in accessory position) and programmed my settings back into the truck . It prompted me to turn the key off, then back on, but not starting it....like normal. I let the truck run for a bit. It sounded pretty bad (knocking). Then turned the truck off.....waited a couple, and started it back to see if it would hold my settings, and it had reset again.... Just some more FYI. Thanks guys ! |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
