2-1/16" Dash Clock (or any 2-1/16" gauge for that matter) 2WD Models

[Longshot270]

Oh, is that what that is? Haha
I tried to make coins fit but they kept falling out.
How did you take it out initially? I get the part of trimming it down I am just curious about how you got started.

[Punisher]

The piece is just held in by a couple of molded in clips. Just grab hold of the change piece and give it a good tug. May take a time or two. Much like the center console surround-trim that is around the radio/climate control. The first time you'd swear you're going to break something. After that it becomes easier each time. If you prefer, you can remove the surround-trim and reach inside around the back of the change holder and push it out from the backside. Again, either way it's just held in with molded plastic clips.

[Longshot270]

Well now I wish I had paid more attention because I had that area opened up because I was installing a remote starter. I'll see if I can find something to put in its place then because I dont really like it. Maybe I'll make a GPS holder to put in there.


Later: Wow, that was actually pretty easy I just never tugged enough to pull it out. But now I'm really curious as to why a coin holder needs a wiring harness? --- I'm thinking about getting my wire tester and seeing if they are actually hot.

[Punisher]

The wiring harness is for the 4WD control on vehicles equipped with 4WD.

[Longshot270]

Originally Posted by Punisher

The wiring harness is for the 4WD control on vehicles equipped with 4WD.

Dang, I was hoping it was for a built in vending machine.

[XPerties]

Originally Posted by Punisher

The wiring harness is for the 4WD control on vehicles equipped with 4WD.

Correct but also incorrect. I have a 4x4 but I have a manual 4x4 with 4x4 shifter on the floor. I have the coin holder as shown in the picture so this mod isn't just for 2WD only.