Display/Screen Info. Intermittent

[bambo2888]

Originally Posted by Longshot270

Try checking the truck's wires that go into the port maybe. Which PID's are you watching?

I examined the connections at both the port and the gryphon, and it all looks fine. I have been watching Speed/Inst MPG/CHT/TFT. I just changed CHT to Battery Voltage to monitor that, as suggested above.

[Longshot270]

I just noticed that you have an aftermarket sound system. Does the screen freeze when that is running? Interference from high power stereo systems, cell phones and even alarm systems can cause the processors to freeze.

[bambo2888]

Originally Posted by Longshot270

I just noticed that you have an aftermarket sound system. Does the screen freeze when that is running? Interference from high power stereo systems, cell phones and even alarm systems can cause the processors to freeze.

There doesn't seem to be any correlation between them. I have had the system /alarm for over a year, and the gryphon for only 3 months, but the problem only just started happening on the screen. likewise, the second i press a button, the screen start reading correctly. The speed and MPG PID just stay at "0" until i press a button on the screen.

[bambo2888]

so... does anyone have any ideas? i really want to get this taken care of.

[Longshot270]

I left a post on the moderators forum. If I were you, I would try to contact Bill about this. He will probably know exactly whats wrong.

[bambo2888]

Originally Posted by Longshot270

I left a post on the moderators forum. If I were you, I would try to contact Bill about this. He will probably know exactly whats wrong.

fair enough, i just wanted to exhaust the forum's resources before troubling him. thanks though.

[Longshot270]

Have you ever had the PID's be blank when you start it up? I have a remote starter and today I used it to cranked the truck with but then something fell on the brake pedal and killed the truck(this was after about 5-8 seconds after the gryphon came on). When I cranked the truck again the PID's were blank and didn't have any values. Hit the menu button just like you did and then the screen was back to normal. They may not be related but I figured that it wouldn't hurt to post it just in case you had a similar instance of the truck getting cranked, shut down the cranked again. I cant test it right now but I bet if you were to crank the truck with the key, turn it off then recrank the truck without taking the key from the "on" position then the last thing displayed might be frozen.