|
|
|||||||
| 2004 to 2008 F-150 and Mark-LT 4.2L, 4.6L and 5.4L equipped F-150s and Mark-LTs. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Thu, April 7th, 2011, 07:37 AM
|
|||
|
|||
OK thank you - I will do it tonight. I picked the truck up last night - and sure enough on level 2 it started the codes. I set it back to stock and the truck ran great and has been running great. But now the edge reads a dtc on stock setting - P1000 OBD readiness test not complete. It will clear out - but will come right back. I took the edge in to use my Fusion software to try to upgrade it - which it did upgrade and re calibrate. Took it back out and installed it at stock setting and still the P1000 code. I have not reset it back to level 2 - so I am really thinking it has to do with the edge itself. I will set it to 1 tonight after work and see what happens.
|
|
#2
Thu, April 7th, 2011, 08:32 AM
|
||||
|
||||
|
The P1000 is normal for any time you do a flash programming event on the vehicle. However, aftermarket tuning usually disables that code....returning the vehicle to stock will set that code every time; it's normal.
__________________
Tuning, PCM flashing, and burning chips for 7.3s since 2008. Repairing all aspects of 7.3L Powerstrokes for 25 years. Eight 7.3L PSDs in the driveway including a 1994 Crown Vic and 1973 F100/2002 F350. Looking for the next victim.
|
|
#3
Thu, April 7th, 2011, 08:43 AM
|
|||
|
|||
|
Oh ok - I will set the truck to level 1 tonight and see if any of the ignition codes appear. I hope by doing the edge update and re calibration that maybe things are cleared out and it will go back to normal. I guess I will see tonight.
thanks for all the help guys!
|
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
