Power Hungry Performance Forum  

Go Back   Power Hungry Performance Forum > Ford F-150, Expedition, Navigator, Blackwood, Mark-LT, SVT Lightning and H-D Editions (Disabled) > 2004 to 2008 F-150 and Mark-LT

2004 to 2008 F-150 and Mark-LT
4.2L, 4.6L and 5.4L equipped F-150s and Mark-LTs.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old Mon, March 2nd, 2009, 02:32 AM
lynn2437's Avatar
lynn2437 lynn2437 is offline
Be A Saint
 
Join Date: Feb 2009
Location: Summerset, SD
Posts: 21
lynn2437 is on a distinguished road
Default

Quote:
Originally Posted by Power Hungry View Post
ALWAYS... ALWAYS... ALWAYS... unhook the NEGATIVE battery cable first. There's not conflicting story on this, this is how it is and is basic Mechanics 101. There are two reasons for this:

1) If you are wrenching on the positive terminal and happen to bump the body or any other metal part of the vehicle or engine, you have an instant arc welder. Since nearly every car manufactured today is "negative ground", meaning that the the negative battery terminal is attached to the body, frame, and engine, if you were to accidentally short your wrench while undoing the negative cable, nothing will happen. If you short across the battery terminals... well, it wouldn't matter which side you are working at that point.

2) If you remove the positive battery cable and it should happen to touch the negative battery terminal or body, there is a chance that you could cause a sudden capacitive discharge in any of the onboard electronics which could damage them.

After removing the NEGATIVE battery cable, many people say to turn on the headlight switch in order to induce a drain to discharge any residual stored voltage in any of the electronics, including the PCM. Since in most cases there is already about 300-500 mA of current draw on the vehicle's systems, not to mention additional load from the dome lamps (if the doors are still open) and the hood lamp (if it's not broken), turning on the headlights won't hurt but probably isn't necessary. I've always let it sit 10-15 minutes, but seriously doubt anything over 30 seconds is necessary. Considering that the KAM (Keep Alive Memory) is akin to the memory presets of your radio, you'll find out in short order how long it takes to clear the PCM.

Hope this helps.
Thats what I knew also (always negative first). I am glad you clarified for those who may be unsure because there are posts on other forums telling people to unhook positive and/or negative and I wanted to make sure if it was just negative or both posts.

I did the mod today and everything turned out great. Noticed a nice bump in throttle response. Great mod IMO!

-Lynn
__________________
2004 Screw 4x4 Lariet
Reply With Quote
 

Tags
dwv intake mod

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:12 PM.


All Contents Copyright 2008-2024, Power Hungry Performance