|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Fri, May 27th, 2011, 04:46 PM
|
||||
|
||||
The pod LOOKS like the right version. Can't you push down on the right side (as you look at it) so that it "snaps" onto the dash?
If it won't do that, I'd have to say you may have a pod with a manufacturing defect. - Jack
__________________
 2024 F150 Platinum SCrew 3.5L PowerBoost FX4, Peragon Tonneau Cover, LineX Bed, 35% Window Tint on All Sides and Rear, Full Nose Paint Protection Film, Husky Mud Guards, Lasfit Floor Liners, VIOFO Dash Cam |
|
#2
Fri, May 27th, 2011, 04:49 PM
|
|||
|
|||
|
Yea see i just looked at the picture again....and it looks as if i am only applying pressure to the right side but it was even amount.....i tried snapping but it doesn't want to...
__________________
|
|
#3
Fri, May 27th, 2011, 06:57 PM
|
||||
|
||||
|
Quote:
- Jack |
|
#5
Sat, May 28th, 2011, 01:07 AM
|
||||
|
||||
|
By the angle of your pictures, mine does the same thing. You have to put enough pressure to spread the two dash panels and clip the pod down. By comparing to a fish scale I've got it probably takes at least 8-12 pounds of pressure to clip it in, sometimes more if it is new and being stubborn. Make sure everything is lined up, like the cable is in the appropriate "notch" so that it wont pinch.
__________________
|
|
#6
Sat, May 28th, 2011, 05:11 PM
|
|||
|
|||
|
haha no joke...i read what you said..went downstairs and applied alot of pressure and sure enough it snapped in....i didn't realize it was going to take that much though. thanks bro! problem solved.
__________________
|
|
#7
Sun, May 29th, 2011, 12:58 AM
|
||||
|
||||
__________________
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
