|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Tue, December 13th, 2011, 03:24 PM
|
|||
|
|||
Just an update. Took my truck in today to get 60k service done....fuel filter, TB and MAF clean, tranny flush, etc. Even though I wasn't quite ready for the service, I took it in early to have the DTC code checked out....plus I had a screw in one of my tires.
Right before I walked in to drop off the key, I switched back to stock. When I did, it cleared the code....no more check engine light!!! Crazy. Good to go though. |
|
#2
Wed, December 14th, 2011, 12:22 PM
|
||||
|
||||
|
Congrats......you just cleared the code and forced the truck to do the relearn readiness test.(p1000)....now the pcm will start counting the occourances again and the code will/might come back...
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
#3
Wed, December 14th, 2011, 09:22 PM
|
|||
|
|||
|
Ah!...gotcha. Well that sucks b/c the problem is probably still there. I guess as long as the truck is running okay, I'll leave it be. Might call my mechanic and give him the code directly though so he can check it out the next time it's in there.
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
