Stock Rev Limiter

[are-jay180]

I adressed the problem with my rev limiter being set to low (4200) by increasing it to 5500 in the custom tune settings, but it still wont shift from 2nd to 3rd, it just hits the rev limiter (at 5500), any help would be much appreciated, I am running an Edge CTS w/ K&N Intake and Magnaflow Exhaust (Single to Dual Side Exit)
Thanks!

[lucky79]

Try setting your rev limit to 5250, that should be Ford's specs that Edge uses in the '09 5.4L models. The only reason I say this is because i had mine at 5400 and it was still shifting acting goofey. Spoke with Edge and they told me to try 5250 (Ford's stock rev limit) and it works well thus far. Hope this helps.

[jhoyt717]

ok here is the deal. when in custom tunes there are wot shift points and there is the regular rev limiter. You need to make sure that the wot shift points and the rev limiter dont coincide with each other. By this i mean that say you set your rev limit at 4206 and the wot at 4207 it will not shift because the rev is set to low. the rev limit needs to be set at around 5600 or 5700 and you should be fine.