![]() |
|
New Member Introductions
Welcome to the Power Hungry Performance Forum. We're glad that you're here! Start a new thread and tell us a little about yourself! PLEASE POST TECHNICAL and/or SUPPORT QUESTIONS in the APPROPRIATE SECTION of the FORUM |
![]() |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
![]()
The 2714 value you're using for your tires looks right to me. Don't change it.
The thing is, you've got low ratio gearing at 3.55, and bigger tires than stock. This has the effect of reducing your "effective" gearing still further and is reducing your available torque. The engine is operating at a lower RPM than "optimum". From your description, this problem seems to be happening around the 3-4 upshift (and possibly the downshift too. So, that's the only change I'd make. I'd change the part throttle 3-4 up/downshift points by +5. This will keep you in 3rd gear longer as you speed up and will drop you into 3rd gear sooner as you slow down. Then, change the 4th gear torque converter lock/unlock points to +10. That keeps the torque converter unlocked longer/sooner which keeps your engine revving higher during the 3-4 up/downshift. I don't think you need to change any of the other settings. I don't really think you are gaining enough from Level 3 to offset the higher cost of fuel. This is something you have to figure out though. I DO know that Level 2 is a very good all-around tune and it's the only one I used before getting custom tunes. I think it's the one you should be using in off-road driving too. Are you hurting anything? Probably not, but that's easy to say, isn't it? - Jack |
#2
|
||||
|
||||
![]()
Only move the points up. By doing that it helps keep the engine in a more powerful RPM range. The graph I posted should help you conceptualize what is happening. Also, because of how low your effective gearing is, the TC cannot downshift properly at what is probably the assigned speed. I remember Cody saying that the TC cannot lock if the resulting RPMs are below 1100 RPM (shifts may also be that was also). The computer will do some compensation based on load but because of how extreme your case is, even the standard compensation apparently is not enough. +2 may help, if it does then you are good, if not then keep going.
__________________
|
#3
|
||||
|
||||
![]()
Alright, this seems to help alot. I test drive it again yesterday for a while and it seems much better, but I'll probably raise the points a little more like y'all suggested . Thanks again !
__________________
EVERYTHING IS BIGGER IN TEXAS |
![]() |
Thread Tools | |
Display Modes | |
|
|