Trying to bridge????

[Justin]

Can you put the plugs in incorrectly? Dont really see how that could happen. The key is on with out the truck running. It was working fine when i pulled into the driveway last night, then when I started the truck this morning thats all I got, even after I let the truck get good and warm. It is pretty cold outside, but I wasnt trying to program it or anything just turned the truck on and thats all I could get. And yes the truck is a 2000.

[Jackpine]

Ugh - OK, this is an "in use problem". Have you disconnected the Gryphon, turned the ignition ON, and then tried plugging it back in? (And maybe, looking at your original post, you HAVE tried that! - Sorry, I've had a busy day).

At this point, I haven't a clue unless it's possibly a low voltage problem (which I doubt). Wish I knew more about your MY programmer! I think the Mad Doctor is going to have to jump in here. Sorry, Bill - Help!

- Jack

[Justin]

Well, thanks for trying to help. Ive tried everything i could think of including pulling it all out and checking the cable and the ends to make sure they didnt get pinched or anything.