|
|
|||||||
| F.U. Chip & FU2 Flex Chip (DISCONTINUED) (Disabled) If you have a question or comment relating the new F.U. Chip or FU2 Flex Chip, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Wed, September 2nd, 2009, 04:13 PM
|
|||
|
|||
Where did YOU mount your 6 pos switch???
Just curious where everyone has mounted there 6 position switch, hopefully with pics but not necessary..
__________________
2002 F-250 CrewCab LB AFE ProGuard 7 intake 4" Magnaflow ss exhaust with 4" downpipe BTS Trans Valvebody Dieselsite Adreneline HPOP Garret GP38R turbo PHP Phoenix FU |
|
#2
Wed, September 2nd, 2009, 04:28 PM
|
|||
|
|||
|
I put mine on the left side of the steering wheel centered under the headlight switch. It is very low profile and that is what I wanted.
I had to take the fuse block off it's mounts to run the switch wire and mount it back up when I was done but it was not that much work and I think it was worth it. I will try to send a picture later Joe
__________________
 2003 4x4 F350 Super Duty Crew Cab Short Bed4" Down pipe and exhaust, Wicked Wheel, Modified Exhaust Turbo Housing, Big Head Waste Gate Actuator, PML Transmission Pan, Factory Tech Valve Body, Autometer Gage Pod, PHP FU2 Chip |
|
#3
Wed, September 2nd, 2009, 04:54 PM
|
||||
|
||||
|
I put mine here, very easy to reach and change w/o having to look away from the road.
__________________
the  1997 F-350 XLT 7.3L PSD 4x4 CC LB BTS E40D Manual Hubs 4.10 36000 miles when purchased 4/1/06. Mods - ISSPRO Performax gauges, Tymar intake, Tymar 3x4 DP to 4" ss exhaust, electric fuel, CCV mod, tru-cool 4739, Swamps 175/30% injectors, stage I Stealth pump, D66 turbo  Spearco 6.0 cac, BDP live tuned tuned 442hp/860tq.
|
|
#4
Wed, September 2nd, 2009, 07:00 PM
|
|||
|
|||
|
mine is hanging from the trailer brake controler, havn't gotten around to drilling the hole in the dash yet. Give me some time, it only took me 1 1/2 years to finally install my gauges in the truck...
|
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
