|
1999 to 2003 7.3L Power Stroke Diesel 7.3L Power Stroke Diesel equipped Super Duty and Excursion. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Theoretical ¼ mile times
Ok, I am sure this question has been asked a 1000 times (I’ve tried searching but couldn’t find anything). I was wondering what type of ¼ mile times would my truck run? I have no intentions of running it, just curious.
My truck: 99 ecsb 4x4, 4r100, late 99 motor, early 99 suspension, PHP FU chip, 4” exhaust, Airaid intake, AIH delete, 05 front end, 265/75/16 tires, wicked wheel, deleted pedestal, ebpv delete, 93K, HPX, 3.73 Assume running it on the race tune |
#2
|
||||
|
||||
Funny you asked this just now.
I ran on the strip Friday night. Although I didn't run a "stock" tune down the strip, I did run one that should be in the 60-80 HP range and it did a 16.7 at 84 MPH. However, that's in a regular cab 2wd truck with a lot of off-the-line tire spin....your results will vary with a 4x4 Supercab.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#3
|
|||
|
|||
Quote:
__________________
2000 F-250 SCLB 2wd 7.3 auto PHP stock-65t-80dd-120race-high idle-no start 4"tb exh, wicked wheel, 3 guages, AIS, coolant filt, |
#4
|
||||
|
||||
Slicks and a locker. The factory limited slip is just that...."limited".
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#5
|
||||
|
||||
Quote:
|
#6
|
||||
|
||||
A stock-tuned regular cab with a standard launch should be in the 76 MPH range at the 1/4.
A crewcab shortbox would be in the 73 MPH area. A supercab would be somewhere in the middle. Your truck should be in the 83-85 MPH range. ET depends on traction off the line in that case.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
#7
|
|||
|
|||
It seems with my truck (not sure if the description is correct, added wicked wheel, PHP custom tunes, and 6637 filter) a boosted launch isn't as quick as punching it off the line. With a boosted launch, it seems like it takes longer/higher rpms to change gears. When punching it off the line, the gears just fall through nice and smooth. I can build about 10psi on a boosted launch before breaking traction.
__________________
01 F350 7.3 4x4 CC SRW/3.73/315-75-16/Aeroforce Interceptor/BD Thruster II/ Bellowed Up-Pipes/4" turbo back exhaust/CCV Mod/DIY 6637/FPR Shimmed to 65 PSI/TS chip reburned with PHP tunes (Stock, 40T WITH Whsiper tune, 80DD, 100R, 140Ex, 140SS)/Replaced and Cleaned EBPS & Tube 4-6-12/Zoodad mod/Recon smoked cab lights/MM Hubs/Cowl Hood/HPx |
#8
|
|||
|
|||
my wife went 15.9 at 82 mph in our truck. track elv 500 ft 80^ day. This was 8 yrs ago. She would powerbrake into boost and launch in 4wd then switch to 2wd. I told her after 3 passes....that be enuff or we wont be able to tow our low 12 sec mustang home(could drive it but no AC and cruz control for 1100 mi is a pain lol)
__________________
01 F250 Lariat PS 7.3 auto SB CC 4x4 old superships microtuner, 285/75/16 Cooper Discoverer ST's, Aero straight thru stainless steel muffler, Access tonneau cover |
#9
|
|||
|
|||
How safe is it to start off in 4x4 then switch to 2x4? Seems like that would be hell on the transfer case cuz everything is still turning with the hubs locked.
__________________
01 F350 7.3 4x4 CC SRW/3.73/315-75-16/Aeroforce Interceptor/BD Thruster II/ Bellowed Up-Pipes/4" turbo back exhaust/CCV Mod/DIY 6637/FPR Shimmed to 65 PSI/TS chip reburned with PHP tunes (Stock, 40T WITH Whsiper tune, 80DD, 100R, 140Ex, 140SS)/Replaced and Cleaned EBPS & Tube 4-6-12/Zoodad mod/Recon smoked cab lights/MM Hubs/Cowl Hood/HPx |
#10
|
||||
|
||||
Quote:
The truck will not come out of 4x4 for the entire length of the track. With a torque load on the transfer case, the shift motor will not be able to "suck" the front drive shift collar back. It's a huge waste of time (not to mention attention) to waste on something that's not doing anything anyway. A manual-shift transfer case MAY have a chance, but good luck wrenching on the lever hard enough to get it pulled out of 4wd with power applied.
__________________
Tuning, flashing, burning chips, and repairing all aspects of 7.3L Powerstrokes. SEVEN 7.3L-powered vehicles in the driveway. Two didn't come that way from the factory! |
Thread Tools | |
Display Modes | |
|
|