|
|
|||||||
| 6.0L PSD FICM Reprogramming Power Hungry Performance revolutionized the 6.0L FICM (Fuel Injection Control Module) programming and has been the industry standard for FICM modification for almost 15 years. If you have questions or would like more information about the benefits, please post here. |
 |
|
|
Thread Tools | Display Modes |
|
#1
Mon, May 14th, 2012, 01:29 PM
|
|||
|
|||
FICM programmer used for ECM rollback
Bill or anyone,
I have heard that with one of the PHP purchased FICM programmers you can also use it to load a new (old) programer "perferred". How is this done? And is there cost on top of the FICM programmer purchase? I ask becauce my FICM programmer should be here in a few days. Thanks Baron 
|
|
#3
Thu, June 7th, 2012, 07:05 PM
|
||||
|
||||
|
Its not locked to one truck per say, as bill does the rollback remotely for each truck using the programmer(gryphon mono chrome display) to do it. So it is time consuming, and would take awhile to roll back each of your trucks. Once its changed(again by Bill remotely) to a FICM programmer, you can tell him how many trucks you intend to program and he'll "unlock" for that many trucks. Once a truck has been programmed with the FICM programmer you may change the programs from Mileage, A40, A80 and Herc to your hearts content on each and everyone of them.
I hope this helps
__________________
19 F-350 6.7 Auto 16 F-350 6.7 Auto 05 Excursion 6.0, Auto, PHP Atlas 40 FICM, ARP Studs VXBC6(truck PCM) 00 F-350 7.3, 12 Speed, PHP Gryphon, PHP hydra, DAC3 95 F-Superduty 7.3 DI, Auto, Mechanics Truck 94 F-Superduty 7.3 DI, 5 speed, Flatbed
|
|
#4
Wed, June 20th, 2012, 11:47 PM
|
|||
|
|||
|
Im with the OP here on this if I read right on the site it says the ECM rollback is $50 for previously modified FICM. So Im assuming that since your buying the $400 FICM tuner it would be $50 to have a rollback correct? I want to know cause I have the VXAP1xx strategy and want to change it.
|
|
|
|
Linear Mode
