New Member - Hoosier Windmills

Hoosier Windmills · #1 Sun, July 24th, 2022, 05:46 PM

Hi: My name is Todd and I have a 1998 IH 4700 with the T-444E - 6 speed with 2 speed axle, 24,000 original miles on engine and chassis. I have a Terex 2863 boom mounted on the truck that I use to install water pumping windmills and towers. Weight of the truck is just under 26K with full fuel, 2 passengers, man basket, and tools. I bought the Orion reflash looking to improve the driveability of the truck as far as acceleration. Mileage improvement would be welcomed as well!

Once I get the calibration file installed, I'll provide some feedback on my experience.

***Power Hungry*** · #2 Tue, July 26th, 2022, 02:51 PM

Good to have you with us, Todd.

Look forward to hearing your thoughts on the Orion.

Hoosier Windmills · #3 Tue, July 26th, 2022, 04:14 PM

Thanks Bill. I reflashed the truck last night and set the power level on 4 like you recommended since I don't have a pyro installed yet. WOW, what a difference! My engine was stock at 190HP and this jump to 230HP made a world of difference! I can actually accelerate in 2 speed axle high at highway speeds! The truck would barely accelerate in any gear in 2 speed high, but now I can take off in low and leave the axle in high. The difference in torque on the low end and taking off is an AMAZING improvement! I'm looking forward to tracking mileage now to see if there are any improvements, although, due to the increased driveability, I wouldn't care if it stayed the same! Thanks again for a great product and support! I will definitely stay in touch as I continue to upgrade the truck.

***Power Hungry*** · #4 Wed, July 27th, 2022, 09:05 AM

Quote:

Originally Posted by Hoosier Windmills

Thanks Bill. I reflashed the truck last night and set the power level on 4 like you recommended since I don't have a pyro installed yet. WOW, what a difference! My engine was stock at 190HP and this jump to 230HP made a world of difference! I can actually accelerate in 2 speed axle high at highway speeds! The truck would barely accelerate in any gear in 2 speed high, but now I can take off in low and leave the axle in high. The difference in torque on the low end and taking off is an AMAZING improvement! I'm looking forward to tracking mileage now to see if there are any improvements, although, due to the increased driveability, I wouldn't care if it stayed the same! Thanks again for a great product and support! I will definitely stay in touch as I continue to upgrade the truck.

Glad to hear you're enjoying the upgrade.

In most cases, customers have notices an increase in fuel economy. At worst, it stayed the same but the truck drove significantly better. Once you settle in to the new tune, you should be able to see some mileage improvement. It usually takes a couple weeks to observe as people usually play with the tuning a little bit and it takes some time for the "shiny" to wear off.

Keep us posted how it goes.

***PHP Ward*** · #5 Thu, July 28th, 2022, 03:02 PM

Quote:

Originally Posted by Hoosier Windmills

Hi: My name is Todd and I have a 1998 IH 4700 with the T-444E - 6 speed with 2 speed axle, 24,000 original miles on engine and chassis. I have a Terex 2863 boom mounted on the truck that I use to install water pumping windmills and towers. Weight of the truck is just under 26K with full fuel, 2 passengers, man basket, and tools. I bought the Orion reflash looking to improve the driveability of the truck as far as acceleration. Mileage improvement would be welcomed as well!

Once I get the calibration file installed, I'll provide some feedback on my experience.

Welcome to the forum!

As Bill said, it usually take a little while for any mileage improvement to show up, since it takes a while for the fun of driving a peppier truck to die down.

Hoosier Windmills · #6 Thu, August 4th, 2022, 02:48 PM

I had the truck out again for a service job Tuesday evening and I was completely amazed at the difference in the truck! I really need to time the acceleration from 0 to 60 mph because I swear it is TWICE as fast to get there as to what it would do before! Just can't say enough good about the Orion! Thanks!

***PHP Ward*** · #7 Fri, August 5th, 2022, 10:08 AM

Quote:

Originally Posted by Hoosier Windmills

I had the truck out again for a service job Tuesday evening and I was completely amazed at the difference in the truck! I really need to time the acceleration from 0 to 60 mph because I swear it is TWICE as fast to get there as to what it would do before! Just can't say enough good about the Orion! Thanks!

We're glad you like it! If you ever need anything, just let us know.