Gryphon not seeing vehicle Calibration after Jump start/new battery install HELP

[Jackpine]

Just a question Bill, would a defective OBDII cable cause the errors he's getting when plugged into Pegasus? Did it somehow corrupt the firmware (or the internal state of the Gryphon) to the point where Pegasus simply cannot communicate or make sense of anything?

And, if this is the case, is it possible the cable itself is OK but that the damage is confined either to the software or the hardware (probably software) in the Gryphon itself?

I only ask in an attempt to understand how damage can occur.

- Jack

[88Racing]

Originally Posted by Mud Digger

so after about a month now after jump starting my truck with my programmer still connected i have come to the conclusion that i think i Fried it... I think i will need bills help on this one and i just want to post this out there so everyone knows. i just downloaded pegasus because i could not tune or even read my DTC's on my programmer and i went to plug it in and it said this...THIS DEVICE IS IN A PERMENENT UNRECOVERABLE CONDITION AND IS CURRENTLY UNABLE TO BE REPROGRAMED VIA USB PLEASE CONTACT PHP


what do i do i need these tunes for my truck and its worthless right now to me..help

Just so Bill doesn't forget.....fill out a support ticket....link is in my sig.