|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Wed, June 24th, 2009, 12:26 PM
|
||||
|
||||
Just had a BF(brain fart) from my old stereo install days.
Banks are you running a trailer braking device? If you are maybe the OBII cable is to close to the out put and if it is it should not be running in close proximity and parallel(=) to it. Need to get one or the other away from each other and or run the cables perpendicular.(+) Just a thought! Lars
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
#2
Wed, June 24th, 2009, 01:09 PM
|
||||
|
||||
|
Quote:
Mines up higher on the right side, on the lower trim panel of the dash. - Jack |
|
#3
Thu, June 25th, 2009, 08:33 PM
|
||||
|
||||
|
yes my braking device is on the right side of the steering wheel and mounted to the lower part of the dash. i have no radar or anything that lays near or on the dash board. when i think about now, i noticed it froze up was every time i was stopped at a red light. going to pull the camper again this coming week for 4 of july i will keep a good eye on it, think i may have to move the braking device
|
|
#4
Fri, June 26th, 2009, 12:48 AM
|
||||
|
||||
|
Quote:
Lars
__________________
SENIOR MODERATOR--PTLA God doesn't have a Facebook but he's my friend. God doesn't have a twitter, but I follow him. |
|
|
Hybrid Mode
