|
|
|||||||
| Towing This forum is specifically for questions, comments, or ideas about towing with your vehicle. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
Fri, August 7th, 2009, 01:55 AM
|
|||
|
|||
Putting the displays near each other should be an issue, you just have to make sure you're not running the 2 sets of cables parallel to each other. The interference primarily comes from the 12V power in the break controller bleeding into the the signal cables for the Gryphon. LCD displays themselves are immune to EFI, it's only their cables that are sensitive so as long as you run the cables in 2 different paths you should be okay.
__________________
2007 F150 Screw 5.4L FX4 
|
|
#2
Fri, August 7th, 2009, 10:47 AM
|
||||
|
||||
|
Trouble is, both cables plug into the backs of their units (I'm assuming the cable to the brake controller does too), and that means they're going to be "close" for at least a little bit.
- Jack
|
|
|
|
Hybrid Mode
