Stall Question

[jconna]

The first time I noticed it was backing into my parking spot at work the day after I installed my unit. This was 4 days ago and it's happened in the same scenerio each day since but today to the point of a stall. Not sure what to make of it.

As for idle.....Idle's high on start up 1300 or so and then drops down to around 600. It's habit that I never pull out before the idle down and I can't say I notice much difference now vs. before I installed the programmer. Seems to take about the same timeframe and drops to around the same level. If anything....RPM's may baseline a little higher than before. It used to drop to around 500 before I pulled out. Once warmed up.....It appears to run around 700 now which does seem higher than before. I believe even once warmed up before installing the programmer it would still hang around the 500 mark but I can't promise my memory is serving me correctly on that. Overall in answer to your question....It apears to run a little higher RPM at idle across the board.

The possible issues you are mentioning make sense as to the possible cause of the issue but I don't get why they never occurred before I installed the gryphon. All I can figure is that it modified settings based on the assumption that everything was in good working order when in fact I do have an issue with one of the mentioned. Overall I'm happy....Much better acceleration and shifting....This stalling issue has me a little concerned though. Something that is going to drive me crazy until I figure it out.