Screwed my gryphon up

[Jackpine]

Originally Posted by Burns331

Didnt think of that....sheesh





I did, he called me back later in the day. I missed it so i called him back with in 30 min and he was busy. Said he would call me back later.

But never did.


So im still with out a programmer, and Im kinda worried about burning up my motor. It really runs like crap and doesnt have any bottom end.

Hopefully he will be able get me set up tomorrow.

Why do you think you'd burn up your motor? At the stock tune, it's just like it came from the factory. Yes, it doesn't run as well as it did when it was tuned, but that won't hurt it.

- Jack

[Burns331]

Originally Posted by JackandJanet

Why do you think you'd burn up your motor? At the stock tune, it's just like it came from the factory. Yes, it doesn't run as well as it did when it was tuned, but that won't hurt it.

- Jack

Well the truck originally had a 4.6l engine in it. I put a 5.4l in it and used the stock 4.6l computer system.

The truck probably wont burn up. But im sure its lean, i dont know how much though.

[88Racing]

Originally Posted by JackandJanet

Why do you think you'd burn up your motor? At the stock tune, it's just like it came from the factory. Yes, it doesn't run as well as it did when it was tuned, but that won't hurt it.

- Jack

Take a look at his about me in his user profile.
He's got some goodies that will throw codes while running a stock program.

[Jackpine]

Originally Posted by 88Racing

Take a look at his about me in his user profile.
He's got some goodies that will throw codes while running a stock program.

OK, bad on me. So the answer is, keep trying to get Bill, realizing he's ALWAYS very busy, and don't drive your truck more than you have to. And especially, don't "push" your truck to do supertruck things.

- Jack