|
|
|||||||
| Gryphon Programmer (Disabled) Edge Product has discontinued the Edge Evolution 2, but we still provide support and tuning for it. If you have a question or comment relating the Gryphon (or Evolution) programmer, post it here. |
|
|
Thread Tools | Display Modes |
|
#12
Tue, July 27th, 2010, 08:26 PM
|
||||
|
||||
Are you sure it wasn't either a D2 error or F1 error?
If it was an F1 error then try this: 1. Leave the ignition key in the ON position. 2. Disconnect the Gryphon at the OBDII port. 3. Plug the Gryphon back into the OBDII port. 4. After getting to the main screen, wait 15 seconds for needed parameters to be loaded. If it was a D2 error then we can almost be sure that an important part of the cable or the programmer failed. Does the programmer light up and show the little parameters when your driving?
__________________
Last edited by Longshot270; Tue, July 27th, 2010 at 08:36 PM. Reason: posted double |
|
|
Threaded Mode