|
|
|||||||
| Minotaur Automotive Tuning Software Tune your own 7.3L Diesel! If you have a question or comment about Minotaur? Post it here. Also, check out our Facebook group: Facebook - Minotaur Tuners |
|
|
Thread Tools | Display Modes |
|
#8
Sat, December 11th, 2010, 08:57 PM
|
||||
|
||||
Reason I dont think it is the sensor is because when it is unplugged the default to 68*(which it displays) - I went in an changed the default - and whenever it is set lower than 0*F it displays 500*.
This leads me to believe the Scangauge is not set up to read below 0*. 
|
|
|
Threaded Mode